Esplora le applicazioni ORC
Check the latest news about our innovative business activity
In November, the model platform that can be connected to the single-phase 230 V (50 or 60 Hz) power grid is being released. From December the kaymacor ORC modules will be able to be connected to single-phase 230V networks. This possibility is limited to the KC4LT and KC5MT models since the legislation provides for connection to the single-phase network only up to an electrical power of 6 kW. The platform is open to the development of single-phase applications at voltages other than 230V.
Kaymacor collaborates with the Greek company OLOKLIROMENO KENTRO ANAKIKLOSIS SA and the Institute of Chemical Engineering Sciences based in Patras as part of a research on a new technology on the recovery of hazardous waste, to remove total organic carbon (TOC) by converting it in gas. In this project Kaymacor supplies the ORC unit capable of transforming the useful heat present in the gas flow into energy. For this reason, in December Kaymacor will install a KC MT 5 unit, that is a 5 kW unit at medium temperature (180 °). For this application, kaymacor has also designed the economizer that recovers heat from the fumes of the innovative process. The solution identified is a double spiral coil solution. Kaymacor calculated and designed the compo. Then he sent the construction drawings to the final customer to build the economizer directly on the plant.
Kaymacor and solar cooling applications The Kaymacor low temperature models (KC-LT) can be used for solar cooling applications. Fed with water in the temperature range of 60 - 110 °, they provide the electrical power needed to power traditional steam compression cooling cycles. The company has built three plants by integrating its technology with concentrating solar collectors. In this context, a low temperature model will be delivered in December to the National Research Institute of Astronomy and Geophysics NRIAG in Cairo in Egypt. The possibility of powering the ORC from both a solar source and a biomass boiler makes the ORC a unique technology able to use two renewable energy sources in parallel (sun and biomass) and to be able to store energy not only in batteries but also in thermal form. ORC machines can also be used in conjunction with absorption machines. In this case, the overall efficiency of the solar cooling system increases further.
Kaymacor ORC for solar & cooling integrated with solar thermal collectors produces electricity and heat. The system made by ORC+thermal solar fields has specific features, as it can: • implement a heat storage • cogenerate thermal and electrical energy together • be supplied in parallel by other renewable sources like biomass (hybrid plants). • Morgana can work with three types of solar panels: • CPT (Concentric Parabolic Trough) • vacuum tubes collectors • Cassini panels • Morgana ORC for solar & cooling integrate direct condenser dissipator • Good performances are available even at high condenser temperature • It can work in cascade with absorption machines whose electrical consumption are reduced to zero. • Stagnation problem in large solar field are completely solved
A innovative 15 kWel ORC is ready to be installed to recover heat from a biogas combustion engine in operation at a Digestor. The unit is very compact integrating on bord either components of High Temperature Loop and components of Low Temperature Loop
A 4kW el Unit has been successfully commissioned at the Alternative Energy Laboratory CanmetENERGY. The collaboration identified the tenic and regulatory solutions needed to market the product in North America and Canada
Plant electricity consumption is reduced recovering heat from exhaust gas chimney • Electricity production can benefit from incentives • Heat available at ORC condenser can be used to pre-heat combustion air to the burner or other heating applications. • Combining electricity produced value and fuel saving pay back is reduced to 3 y • Modular solution improves efficiency at partial loads, scalability and reliability • Safety ORC installation near the chimney • Monitored in cloud 24 hours a day
• Biogas & Biomethane Plus is delivered in ISO standard-containers and connects to all common diesel and gas gensets from 0,2-1.1 MWe • Biogas & Biomethane Plus is scalable and generates additional 10-100 kWel reducing to zero auxiliaries power consumption • It gives the possibility to get maximum efficiency even at partial loads • It uses of std components in large volumes • Kaymacor Biogas & Biomethane Plus is tested 100% on production line • The modularity solution means that out of service of one module does not stop the whole machine • Quick and cost effective installation • Easily match with different power recovery • Monitored in cloud 24/7 • Supplied turnkey with all circuit components • Full service assistance
ORChidea Low temp solution is designed to fit standard water boilers while the High temp solution works with diathermic oil or pressurized water boilers. Platform modularity allows to design the plant based on local availability of biomass For wood chips and pellet combustion emissions level are in class 5 as per EN.. Orchidea gives the possibility to get maximum efficiency even at partial loads Modules are tested 100% on production line System has a simple interface like that of a household appliance Payback time shorter compared to a standalone biomass boiler
Our partner in Ireland presents the Biogenic Processor. Kaymacor ORC machine is integrated inside it and provides electricity and heat for treating the wasted material.
Contribution Abstract: Organic Rankine Cycle is one of the most efficient, profitable and feasible technology for low-to-medium temperature heat recovery. The boost to the development of small-scale systems that could easily enter the market poses challenges in layout design and selection of components. This work deals with a micro-scale ORC unit conceived to be cheap, efficient and compact. The transient response of the system has been experimentally investigated and simulated with large variations of the heat source. To this end, a dynamic model is built and validated against a large set of experimental data. The final goal is to show the real potential of the system in terms of market applications, for which best design choices, operational limits and response time to variable heat sources must be identified. Results proved the fast time response of the system that promptly reacts to variations of the heat source temperature. The model is able to capture well the system dynamics, showing maximum relative errors of about 5% in the prediction of both output power and high pressure. The choice of scroll expander, volumetric pump and plate heat exchangers is made according to the lowest cost-to-efficiency ratio to keep the investment cost below 2500 euro/kW already at the pre-market phase. The additional heat production (around 15 liters/min at 40°C) amplifies the market potential in isolated domestic applications and paves the way for further cost reductions.
The GeoGrid project aims to develop low- and medium-sized geothermal energy articulated in three research strands: 1 Study and design of polygenerative neighborhood plant with reduced environmental impact powered by geothermal source 2 : Study, design and trial of innovative systems for small-scale geothermal source trigeneration 3 Development and optimization of innovative systems for the sustainable use of low-entalpia geothermal energy embedded in foundation works and their integration with environment conditioning systems Kaymacor provides the orC machine at the heart of the system
• Kaymacor Gen-Set System is delivered in ISO standard-containers and connects to all common diesel and gas gensets from 0,2-1.1 MWe • Kaymacor Gen-Set System is scalable and generates additional 10-100 kWel reducing to zero auxiliaries power consumption • It gives the possibility to get maximum efficiency even at partial loads
The new display allows you to view all plant and internal machine parameters. The layout is designed to make Morgana control simple and intuitive
From now on all Morgana Systems are monitored in real time in the field. The on-board software can be updated remotely. In this way the functionalities of each plant are continuously enhanced and optimized.
Great performences of the prototype tested in collaboration with CNR Istituto Motori and Trieste University
This book provides a systematic and detailed description of organic Rankine cycle (ORC) technologies and the way they are increasingly of interest for cost-effective sustainable energy generation with applications in cogeneration from biomass and from geothermal reservoirs, amongst others. Kaymacor contribution is in the chapter 18th dedicated to Micro-Organic Rankine Cycle systems for domestic cogeneration.
A new espander coupled with a brushless alternator and a new inverter for grid connection are devoleped for such new model.
ORC machine gives the opportunity to recover heat in several industrial processes. In a lot of applications like ironing, pasta factories dairies heat coming out from the chimney of steam boilers or ovens is at high temperature. This heat can be recover to produce electrical energy and heat at lower temperature
In collaboration with University of Florence and others partners a PTC solar field and coupled with an ORC machine is installed at Misericordia Hospital in Florence. This installation is one of the pilot plants reliazed for PIACE project that is coordinated by one of Kaymacor partner.
One of the ORC application is the production of electrical energy starting from solar heat at medium temperature. One limit of such application is solar field costs. That's why Kaymacor acquired three licences for the realisation of a smart solar collector whose cost is very competitive. To develop such Technology the Company also received a money contribution related to Brevetti+ Fund
In a ORC Cycle the pump is a key component due to the difficulties to pump the organic fluid. Moreover ORC pump power consumption can not be negletted as in traditional steam cycles. That's why Kaymacor has developed its own technology.
Integration of the Cycle pump inside the Receiver vessel is an high competitive item for Kaymacor. In this way circuit is simplified, sealing is ensured and all pump motor heat is recovered.
The smallest one of Kaymacor machines, Morgana 2000, is used to recover heat from the gas exhaust of an internal combustion engine. Any thermal source whose temperature is higher than 140°C represents a precious enrgy source which can be transofrmed in electricity and heat at lower temperature.
Kaymacor name derives from KAYMA which in ancient greek means HEAT and COR that is Organic Rankine Cycle in italian words. This name summirize Company mission: Generate electrical power recovering wasted heat from several heat sources like biomass boilers, internal combustion engines and small industrial ovens,